Connect the adapter to the device and connect the device to the adequate power supply.
Immediately after connecting the device to an electric circuit a sensor becomes active, activating the diodes under the lamp once a hand or a foot is placed underneath, operating for 15 seconds. Once the hand or the foot are removed from the area, the light emission stops.
By pressing a buttons on the upper part of the device allows a choice of three different operation modes:
- Pressing of the button “30s” activates a 30 second timer. After 30 seconds, the diodes will turn off and the device will switches to the initial operation mode.
- Pressing of the button “60s” activates a 60 second timer. After 60 seconds, the diodes are turned off and the device switches to the initial operation mode.
- The “Low Heat Mode” is activated by pressing the 99s button. This mode cures gels or permanent polishes for a total of 99 seconds, divided into three phases:
* Phase one taking place with 1/3 of the total lamp power, lasting for 30 seconds.
* Phase two taking place with 2/3 of the total lamp power, lasting from the 30th to the 50th second.
* Phase three curing taking place with the lamp on full power. This phase starts from the 50th second, lasting until the 99th, after which the diodes stop emitting light.
Each mode can be interupted by pressing its activating button.
The lamp has a timer memory function.
By pressing 30s or 60s buttons for 2s the lamp will memorize the selected timer that will be active every time when the selected time ends, or the client pulls his hand out of the lamp.
The lamp also has “double power” mode.
This mode change the basic power of the lamp, it can be activated by activating 30s or 60s timer, and then holding the 99s button for 2 seconds.
This mode, as well as all other modes, can be interupted by pressing its activating button for a short time.
Made in China.
