GALAXY PROFESSIONAL LED/UV Lamp for Curing - Galaxy700 Low Heat

Name: LED/UV Lamp for Curing - Galaxy700 Low Heat
Brand: GALAXY PROFESSIONAL
SKU: 23581
Price: 10750 RSD
Availability: InStock
Rating: 4.55 (11 reviews)

| Write a comment

GALAXY700 professional lamp for curing UV and LED/UV products.
Thanks to the simultaneous double light source of 365nm (nanometer) and 405nm (nanometer), it is perfect for fast curing of:

UV and LED/UV builder gels
UV and LED/UV colour gels
UV and LED/UV gel polishes
UV and LED/UV top coats (matte or glossy)

FEATURES:

27 LED diodes
Maximum lamp power: 48 W
Input operation mode: AC 100-240 V, 50/60 Hz, 1 A
Output operation mode: DC 24V 1.5 A
Dimensions: 200 mm x 170 mm x 100 mm
Timer: 30 s / 60 s / 90 s
Low heat mode: 120 s
Sensor time: 90 s
Changeable bottom

CONTENTS OF THE BOX:

GALAXY700 UV/LED lamp
DC 24V adapter
Protective transport components
User manual
Changeable bottom
Three rubber front covers in different colours (pink, purple and white)

Show less

Connect the adapter to the device and connect the adapter to the adequate power supply;
Immediately after connecting the device to an electric circuit, a sensor becomes active, activating the diodes under the lamp once a hand is placed underneath, operating for 120 seconds;
Once the hand is removed from the area, the light emission stops;
Apart from the mode mentioned above, depending on the required length of gel or permanent polish curing, the lamp can have four other different modes:
- 10 seconds operation mode
- 30 seconds operation mode
- 60 seconds operation mode
- The “Low heat mode”;
10, 30 and 60 seconds operation modes are activated by pressing the designated mode activation button, marked with a corresponding label (10 s, 30 s or 60 s). Once the chosen mode has been selected, the diodes will emit light. After the set time expires, the diodes will stop emitting light;
The “Low Heat Mode” is activated by shortly pressing the 90s button. This mode cures gels or permanent polishes for a total of 90 seconds, divided into three continuous phases:
- Phase one takes place with 1/3 of the total lamp power, lasting for 30 seconds
- Phase two takes place with 2/3 of the total lamp power, lasting from the 30th to the 45th second
- Phase three curing takes place with the lamp on full power. This phase starts from the 45th second and lasts until the 90th, after which the diodes stop emitting light;
Each mode can be interrupted by pressing its activating button;
Before the first use, removing the protective film from the reflecting surfaces is necessary.